AstroStart Security System VSS-113 Przewodnik Instalacji Pobierz pdf (Strona 7)

H1/12 ORANGE/BLACK (-) 500 mA Ground When Armed Output

This wire supplies a (-) ground as long as the system is armed. This output ceases as soon as the system is disarmed.

The ORANGE/BLACK wire is pre-wired to control the starter kill relay. It can supply up to 500 mA of current.

If using the H1/12 ORANGE/BLACK wire to activate an add-on accessory

such as window automation, a diode must be installed to ensure proper

operation. Insert the diode as shown in the following diagram.

CONTROL UNIT

H1/12

ORANGE/BLACK

(-) WHEN ARMED OUTPUT

NEVER INTERRUPT

ANY WIRE OTHER THAN

THE STARTER WIRE.

STARTER

MOTOR

1N4004 DIODE

PRE-WIRED

STARTER KILL

RELAY

T BLUE

LUE

ORANGE/BLACK

OPTIONAL SENSOR

Door Lock Harness (H2) Wire Connection Guide

H2/A ----- BLUE (-) UNLOCK, (+) LOCK OUTPUT

H2/B ----- EMPTY UNLESS USING 451M

H2/C ----- BROWN (-) LOCK, (+) UNLOCK OUTPUT

The door lock outputs are low current and should not be

attached directly to any high current device; they are

only to be used to activate relays or the DLA-2 module.



Refer to the AstroChart software for detailed instructions

about connecting to the vehicle’s power door lock systems.

Peripheral Plug-In Harnesses

SUPER BRIGHT LED, 2-PIN WHITE PLUG

The super bright LED operates at (+) 2 volt DC and plugs into the two-pin WHITE

port. Make sure the LED wires are not shorted to ground as the LED will be damaged.

Multiple LED’s can be used, but they must be wired in series. The LED fits into a 9/32-

inch mounting hole. Be sure to check for clearance prior to drilling the mounting hole.

CONTROL

MODULE

LUE



Never use a BLUE LED in combination with a RED LED.

VALET/PROGRAM SWITCH, 2-PIN BLUE PLUG

The Valet/Program button should be accessible from the driver’s seat. It plugs into the

BLUE port on the side of the unit. Since the system features Valet by using the remote

transmitter, the button can be well hidden. Consider how the button will be used before

choosing a mounting location. Check for rear clearance before drilling a 9/32-inch hole

and mounting the button. The GREY wire in the two-pin plug may also be used as a (+)

ghost switch input and can be connected to any (+) switch in the vehicle.

(See Feature Descriptions section of this guide.)

CONTROL

MODULE

REY

BLACK

1 2 3 4 5 6 7 8 9 10 11 12 ... 17 18

Komentarze do niniejszej Instrukcji

Brak uwag

AstroStart Security System VSS-113 Przewodnik Instalacji Strona 7

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Alarm samochodowy AstroStart Security System VSS-113