AstroStart Security System VSS-113 Przewodnik Instalacji Pobierz pdf (Strona 6)

H1/9 GREY (-) 200 mA Dome-light Supervision Output

Connect the H1/9 wire to the optional dome-light supervision

relay as shown in the following diagram:

NEVER use this wire to drive anything but a

relay or a low-current input! This transistorized

output can only supply 200 mA, and connecting

directly to a light bulb, motor, or other high-

current device will cause the module to fail.

H1/10 PINK/WHITE (-) 200 mA Channel 3 Programmable Output

This wire provides a (-) 200 mA output whenever the transmitter button(s) controlling channel three is pressed. This

output can be programmed to provide the following types of output (see System Features Learn Routine section of this

guide):

 A validity output will send a signal as long as the transmission is received.

 A latched output will send a signal continuously when the channel three button(s) is pressed and released.

The signal will continue until channel three is pressed again.

 A latched/reset with ignition output works similar to the latched output, but will also reset (output will stop)

when the ignition is turned on and then off.

 A 30 second timed output will send a signal for 30 seconds when channel three is pressed. This output can

be shut off during the 30-second period by pressing Channel 3 again.

 This output can also be programmed to provide a second unlock pulse when the unlock button is pressed a

second time after disarming the system. This can be used to unlock the passenger doors when installing

progressive door locks.

NEVER use this wire to drive anything but a relay or a low-current input!

This transistorized output can only supply 200 mA, and connecting directly

to a solenoid, motor, or other high-current device will cause the module to fail.

H1/11 GREEN (+)/(-) Selectable Light Flash Output

As shipped, the H1/11 GREEN wire should be connected to the (+) parking light wire. If the light flash polarity jumper is

moved to the (-) position (see the Programming Jumper section of this installation guide), this wire supplies a (-) 200

mA output. This is suitable for (-) light control.



A standard automotive SPDT relay must be used on the H1/11 light

flash output wire, for parking light systems that draw 10 amps or more.

DO NOT connect this wire to a negative vehicle light flash wire

before changing the light flash programming jumper to the negative

polarity position or damage to vehicle light circuit may occur.

Positive switching configuration

Negative switching configuration

+12V

GREEN H1/11

(+) LIGHT FLASH OUTPUT

OEM PARKING LIGHT

RELAY OR SWITCH

+12V

GREEN H1/11

(

) LIGHT FLASH OUTPUT

OEM

RELAY

OEM

SWITCH

H1/9 GREY

DOME-LIGHT

SUPERVISION

POLARITY (+) OR (-)

DOME-LIGHT WIRE

+12V

CONSTANT

FUSED

1 2 3 4 5 6 7 8 9 10 11 ... 17 18

Komentarze do niniejszej Instrukcji

Brak uwag

AstroStart Security System VSS-113 Przewodnik Instalacji Strona 6

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Alarm samochodowy AstroStart Security System VSS-113